User profile for Eric Thomas – Flair

• This is great to hear Mathew! I do not own a 3D printing business, but I looked into doing this a while back. I knew it was only a matter of time before someone stepped up. Thanks for doing this.

• Why not provide adaptor plates like keen does? I adapted one of theirs to fit a flair unit and it works great.

I don't think there is pent up demand for additional smart vent sizes. There is pent-...

• Hoping someone can help me understand how Flair uses occupancy information for rooms. I'm using my Ecobee as the primary controller thermostat and have comfort settings configured for Daytime, Night...

• Thanks Finn. I didn't notice the notification when this occurred previously, but I'll watch for it in case this happens again. I appreciate the responses. Regards, Eric

• @Finn, I have all the Flair notifications enabled. However, do any of these notifications trigger when a room goes offline or when Flair loses the account linkage to my Ecobee account. Specifically...

• I'm also in Texas with 8x10 vents in the majority of the house, so I'm holding off on buying more vents until I can get an 8x10. For one of my rooms, I bought the Keen trim kit for 8x10 (KHTRMKT810...

• I added my first couple of Flair vents a couple of weeks ago to try to narrow the temperature deltas between a few rooms in my house. First few days showed real progress with two Flair vents...